Yaesu FTM-400DR / 400XDR Cross Band Repeat:
Initial settings
There is no setting of the CW ID transmission in Cross Band Repeat.
Initial settings
- Set [A] band, [B] band in different bands VHF/UHF or UHF/VHF.
- Turn the APRS MODEM setting OFF.
- Set signaling in CTCSS or DCS, as desired possible [A] band, [B] band can have individual settings.
- To Start Cross Band Repeat mode: with the radio OFF push and hold the DSP + F + GM keys and then power ON the radio.
- During Cross Band Repeat mode, the radio becomes a mode for exclusive use of the analog signal and the radio controls will all become dead.
- The cancellation of Cross Band Repeat mode: with the radio OFF push and hold the DSP + F + GM keys and then power ON the radio.
There is no setting of the CW ID transmission in Cross Band Repeat.